Diesel generator set shutdown flameout electromagnet diesel engine oil cut-off solenoid valve flameout 12V 24V
technical parameter
Working voltage: 12V (9-15vdc) 24V (18-30vdc)
Full load East making current: 12v-2.0a, 24v-1.0a (the power supply will be automatically disconnected after the action is in place, and the working unit is less than 15mA)
Working current of control line: < 15mA
Working stroke: 53 ± 1 mm
Maximum tension: 90N
Ambient temperature: - 30 ° C ~ 60 ° C
Action time: ≤ 2
Overload protection: when the flameout is overloaded or jammed, it will stop working automatically to avoid damage to the flameout. After the power supply of the flameout is disconnected for a period of time, it is powered on again, and the flameout can be reset from the fault state to normal operation
Wiring description of flameout:
There are three outlets in the flameout. The explanation is as follows:
Red: connected to the positive pole of the power supply; yellow: connected to the negative pole of the power supply; green (or blue) is the control line
Normally open type: when the control line is powered on, the flameout will act and stop automatically when the action is in place. After power failure, the flameout is released and automatically stops after the action is in place.
Installation and precautions
During installation and commissioning, it should be ensured that before the flameout is in place, the diesel engine stop control lever does not move to the limit position and the flameout will be stuck. Otherwise, the internal overload protection circuit of the flameout will act, and the flameout will stop working automatically. At this time, the power supply of the flameout should be disconnected, and after adjusting the installation position, the flameout can be powered on again, and the flameout can resume normal operation
Audited Supplier 
){kind=link}
){kind=link}